Rebuilt 3.4 Carrera Long Block
Item Details
- Seller: pursuit96
- Location: Miami, FL 33176
- Lot #: P-0009967-DT
Up for auction is this newly rebuilt Porsche 996 3.4L engine. Factory equipped for a 996 Carrera and rated at 296 HP, this flat-six VarioCam engine was pulled from its original vehicle following failure of the air/oil separator at approximately 71k miles. It has since been completely rebuilt by the seller, a Porsche technician with over 35 years of experience. The main and rod bearings were replaced along with all chain tensioners, rod bolts, crank cage bolts, cylinder head bolts and piston rings. An Upgraded roller IMS bearing was installed as well. The heads were pressure checked for cracks and a valve job performed and a new oil cooler was fitted. There have been zero miles added to the rebuilt engine and the buyer will have to supply their own intake manifolds, fuel system, electrical harness, and auxiliary accessories. The buyer is responsible for shipping, handling, and fees.
Auction Results
- Sold for: $8,500
- Auction End: May 04, 2021 08:18:51PM UTC
- Number of Offers: 2
Comments (26)
Sold for $8,500
Offer in the amount of $8,500
I’m out. Good luck all! ??
Offer in the amount of $7,500
Bid in the amount of $7,050
Bid in the amount of $6,500
Regarding the IMS, it is an EPS IMS bearing, dual row length, made in Germany and sold by Vertex in Miami FL
@Lexday47 yes it will
@Lexday47 in the car but trying to answer everyone
@ppalmer the motor is a 2000 and came from a 2000 cab
@Lexday47 the only docs I have are parts receipts. You can see in the photos the pistons, rods etc, all the same.
Bid in the amount of $3,500
Ppalmer I think he stated somewhere it was a 2000 but he has been unresponsive since yesterday
Good Morning
What year is the motor & which model did it come from ?
Thank You
Paul
Are you home pursuit96 ?
I also assume this should fit a 2001 Carrera
Is this build documented and have accompanied paperwork , I bought an engine not from you but a purported reputable engine builder last year that had one piston etc different from the other 5
Bid in the amount of $2,800
Bid in the amount of $500
@VOC4S There are no other "fees". Buyer pays shipping, that is it.
In addition to shipping and handling, what “fees” are you referring to?
@uscarrera 2000
What year car did it come from?
@Moosetaco Stock 96 mm bore. No scoring so cylinders were give a very light hone. The IMS bearing is German, I do not have the box with name on it but you can see in the photo it is a sump lubricated roller bearing, double row width.
@pursuit96 stock sleeves? Also, which IMS bearing did you install?
I just wanted to say a quick Hello to everyone and let you know I am available it anyone has any questions.